0
Research Papers

The Effect of Process Variables on Extrusion Pressures of Lead

[+] Author and Article Information
J. Frisch, E. G. Thomsen

University of California, Berkeley, Calif.

J. Eng. Ind 81(3), 207-214 (Aug 01, 1959) (8 pages) doi:10.1115/1.4008304 History: Received July 02, 1958; Published August 01, 1959; Online February 20, 2019

Abstract

Billets of commercially pure lead, 2 in. diam × 3 in. long were extruded at room temperature through five different die contours at ram speeds up to 50 ipm. It was found that, for the direct and indirect extrusions, with good lubrication (white lead in oil) and with good cylinder-wall finish, the extrusion pressure-displacement diagrams were essentially the same. The concentric and eccentric single-bar and multibar extrusions at constant extrusion ratio required approximately the same pressures when extruded at identical speeds. The extrusion pressures over the wide range of speeds investigated showed approximate linearity when plotted on log-log co-ordinates.

Copyright © 1959 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In