Damping Capacity of Turning Tools, Part 2: Mechanism Initiating the Damping Capacity

[+] Author and Article Information
M. Hashimoto

Department of Mechanical Engineering, Toyota College of Technology, 2-1 Eisei-cho, Toyota-shi 471, Japan

E. Marui

Department of Mechanical Engineering, Gifu University, 1-1 Yanagido, Gifu-shi 501-11, Japan

S. Kato

Nagoya University, 4-1-76 Tokugawayama-cho, Chikusa-ku, Nagoya 464, Japan

J. Eng. Ind 115(3), 366-370 (Aug 01, 1993) (5 pages) doi:10.1115/1.2901675 History: Received August 01, 1991; Online April 08, 2008


This paper examines the mechanism initiating the damping capacity of a turning tool. The turning tool is considered as a beam on an elastic foundation. Parameters of the model are estimated from the experimental result of the free damped vibration frequency. Next, the magnitude of damping energy is calculated from the friction resistance and the relative slip between the tool shank and the tool post (elastic foundation) during vibration in both tangential and normal directions. The calculated result of damping energy agrees well with the experimental result of the damping capacity qualitatively, for various clamping loads and various surface topographies. This result indicates that the damping capacity of the turning tool system is mainly caused by the relative slip at the tool shank.

Copyright © 1993 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.






Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In