Interpolation is a common procedure in scientific practice. In many cases, linear interpolation is tacitly applied in order to present measurements or numerical results. The application of sophisticated interpolation methods is rather rare, even though they can help to extract more information from a measurement, especially if the resolution is relatively low. This paper presents an interpolation method and a validation procedure, which is demonstrated on experimental data from a low pressure compressor of a twin spool turbofan engine.

As a research test vehicle the Larzac 04 turbofan engine is used, which is equipped with extensive instrumentation and control systems. This publication focuses on the high speed pressure transducers mounted directly above the tip of the first LPC rotor blades. Besides the installation of those sensors in a jet engine, the processing, the storage, and the analysis of the data is challenging, as the sampling rate is extraordinary high (1 MHz). Those sampling rates result in a high circumferential resolution (1 MHz ≙ 2.69 samples per mm at 90% rel. spool speed) compared to the relatively low geometrical resolution of the nine axial sensors (0.23 samples per mm). Therefore, sophisticated interpolation methods are applied on the data points in axial direction, aiming to get the best possible result from the acquired data. A major part of this paper is the discussion and validation of several different interpolation methods. Especially with the Akima sub-spline interpolation, very promising results were obtained.

Finally, some of the results from the fast response pressure transducers are presented. The casing wall pressure distribution and some flow phenomena at the design operating point are compared to the corresponding near stall conditions.

This content is only available via PDF.
You do not currently have access to this content.