0
TECHNICAL PAPERS

Studies on Double-Side Shearing with Parallel and Straight Cutting Edges (Prevention of Tool Breakage by Bevelled Punches with High Slenderness Ratio)

[+] Author and Article Information
S. Mekaru, I. Fukumoto, T. Makishi

Department of Mechanical Engineering, Faculty of Engineering, University of the Ryukyus, Senbarn 1, Nishihara, Okinawa 903-01

J. Eng. Ind 117(1), 67-71 (Feb 01, 1995) (5 pages) doi:10.1115/1.2803280 History: Received May 01, 1992; Revised December 01, 1993; Online January 17, 2008

Abstract

In the present investigation the cutting edge of a slender punch was bevelled in an attempt to prevent bending or breakage in use. Tests with Kovar sheet showed that use of a bevelled punch significantly reduces the risk of bending or breakage, a particular problem when clearance on both sides of the punch is unbalanced. This is because the punch guides itself in the later stage of the stroke. Tool life tests shearing Kovar sheet with the bevelled punch produced a smaller burr on the product than with the conventional punch. The application of such punches is found to be most suitable for thin materials such as are used in the manufacture of IC and LSI parts.

Copyright © 1995 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In