0
RESEARCH PAPERS

Mechanical and Thermal Stresses in Clamped, Brazed, and Bonded Carbide Tools

[+] Author and Article Information
M. A. Younis

Department of Mechanical Engineering, American University in Cairo, Egypt

J. Eng. Ind 114(4), 377-385 (Nov 01, 1992) (9 pages) doi:10.1115/1.2900687 History: Received November 01, 1989; Online April 08, 2008

Abstract

A model based on the finite element method is presented for determining of thermal and mechanical stresses in a carbide insert due to heat and cutting forces induced during metal cutting with a brazed, clamped, and bonded carbide insert. Analysis revealed a high temperature gradient in the brazed insert, thus causing high thermal stresses. For the bonded insert a low temperature gradient but high temperatures were found, leading to possible tool edge chipping and a significant reduction of the bond layer strength. Finally local maxima of tensile and compressive stresses were identified on the rake face just after the chip had lost contact with the tool face. The estimated tensile stresses were close to the transverse rupture strength of sintered carbide. Shear stresses were at a maximum close to the tool edge at levels nearly equal to the shear flow strength of carbides. High compressive stresses can produce chipping at the tool tip.

Copyright © 1992 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In