0
RESEARCH PAPERS

Turning Process Identification Through Force Transients

[+] Author and Article Information
R. Nair, K. Danai, S. Malkin

Department of Mechanical Engineering, University of Massachusetts, Amherst, MA 01003

J. Eng. Ind 114(1), 1-7 (Feb 01, 1992) (7 pages) doi:10.1115/1.2899754 History: Received July 01, 1990; Revised January 01, 1991; Online April 08, 2008

Abstract

A method is presented for identifying the chip formation, plowing, and sliding forces in turning from force transients. For this purpose, a simple model is used which separates the cutting force into a sharp tool chip formation component and a residual component associated with both rubbing between the wear land and the workpiece and plowing at the cutting edge. Variations of the cross-sectional area of the cut during a transient are used to tune the model and estimate its parameters.

Copyright © 1992 by The American Society of Mechanical Engineers
Topics: Force , Turning , Cutting , Wear
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In