0
RESEARCH PAPERS

A New Process of Cold Butt Welding

[+] Author and Article Information
T. Tabata, S. Masaki

Department of Mechanical Engineering, Osaka Institute of Technology, 5-16-1, Omiya, Asahi-ku, Osaka 535, Japan

J. Eng. Ind 113(4), 446-449 (Nov 01, 1991) (4 pages) doi:10.1115/1.2899721 History: Received July 01, 1990; Revised December 01, 1990; Online April 08, 2008

Abstract

An experimental set-up for cold butt welding is developed. Before conventional upsetting of two specimens to be bonded, surfaces of the specimens are shaved off by an edge to bring out the virgin metal which is essential to cold pressure welding. Since the bulk deformation to form the virgin surfaces is smaller compared with the conventional process without using the edge, complete bonding is accomplished with a small strain in upsetting of the specimens. This result leads the following advantages of the present process. (1) Waste of the material which is used as a flash is reduced. (2) The upsetting load, i.e., the bonding load is lower.

Copyright © 1991 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In