0
RESEARCH PAPERS

Tool Face Temperatures in High Speed Milling

[+] Author and Article Information
P. Lezanski

Lodz Technical University, Lodz, Poland

M. C. Shaw

Arizona State University, Tempe, AZ 85287

J. Eng. Ind 112(2), 132-135 (May 01, 1990) (4 pages) doi:10.1115/1.2899555 History: Received June 01, 1988; Online April 08, 2008

Abstract

While it is now generally understood that in continuous chip forming processes such as turning, there is no magic high speed above which tool temperature decreases and tool life increases with increased cutting speed. However, it has been suggested that this may not be the case in intermittent cutting operations such as face milling. It is argued that in such an operation, the tool temperature oscillates between an ambient value at the beginning of a cut and a maximum value at the end of a cut. As cutting speed is increased, the cutting time per cut will decrease and hence the fractional approach to the equilibrium value. Thus, even though the equilibrium temperature will increase with cutting speed, it is conceivable that the maximum temperature at the end of a cut will decrease. This possibility has been tested experimentally using the chip-tool thermocouple technique to record temperature vs time curves for a variety of cutting conditions. In no case was the exit temperature found to decrease with increase in cutting speed.

Copyright © 1990 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In