0
RESEARCH PAPERS

Chatter Vibration in Drilling

[+] Author and Article Information
S. Ema

Department of Technology Education, Gifu University, 1-1, Yanagido, Gifu-shi 501-11, Japan

H. Fujii, E. Marui

Department of Mechanical Engineering, Gifu University

J. Eng. Ind 110(4), 309-314 (Nov 01, 1988) (6 pages) doi:10.1115/1.3187887 History: Received September 01, 1986; Online July 30, 2009

Abstract

Chatter vibration of long drills has been investigated using several drills with different overhang lengths and special drills with different pieces of additional mass. The frequency, amplitude, initiation boundary, and unstable range of chatter vibration were measured at various cutting parameters. The experimental results showed that the vibration is a regenerative chatter and its frequency is equal to the bending natural frequency of the drill when the drill point is supported in a machined hole. Based upon the experimental results, the stability of chatter vibration was discussed. It was clarified that unstable ranges appear only when the chatter frequency in one workpiece rotation is an odd number.

Copyright © 1988 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In