0
RESEARCH PAPERS

Pressbrake Bending in the Punch-Sheet Contact Region—Part 2: Gap Formation and the Direction of Sheet Motion

[+] Author and Article Information
F. Pourboghrat, K. A. Stelson

Productivity Center, Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455

J. Eng. Ind 110(2), 131-136 (May 01, 1988) (6 pages) doi:10.1115/1.3187861 History: Received October 30, 1987; Online July 30, 2009

Abstract

In Part 1 of this paper, simple models of nonuniformities in pressbrake bending in the punch-sheet contact region were presented. An extreme manifestation of these nonuniformities is the appearance of a gap between the punch and the sheet. The models from Part 1 are used in Part 2 to predict the possible formation of this gap as a function of the geometry and the frictional conditions. To determine the direction of the frictional force at the die, methods to determine the direction of sheet motion on the die are presented. Elastic and rigid-plastic material models of the sheet are considered, and are shown to produce remarkably similar results.

Copyright © 1988 by ASME
Topics: Motion , Geometry , Force
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In