0
RESEARCH PAPERS

Pressbrake Bending in the Punch-Sheet Contact Region—Part 1: Modeling Nonuniformities

[+] Author and Article Information
F. Pourboghrat, K. A. Stelson

Productivity Center, Department of Mechanical Engineering, University of Minnesota, Minneapolis, MN 55455

J. Eng. Ind 110(2), 124-130 (May 01, 1988) (7 pages) doi:10.1115/1.3187860 History: Received October 30, 1987; Online July 30, 2009

Abstract

A simple model of pressbrake bending in the punch-sheet contact region is presented. The pressure and shear stress at the punch-sheet interface cause the stress distribution in the sheet to change as a function of angle. In Part 1 of this paper, a model to predict nonuniformities as a function of the geometry and the frictional conditions is presented. In Part 2, the model will be used to predict the formation of a gap between the sheet and the punch. Elastic and rigid-plastic material models of the sheet are considered, and are shown to produce remarkably similar results.

Copyright © 1988 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In