0
RESEARCH PAPERS

Effects of Accelerated Tests on Shear Flow Stress in Machining

[+] Author and Article Information
V. K. Jain

Department of Mechanical Engineering, Indian Institute of Technology, Kanpur, 208016 India

B. K. Gupta

Department of Mechanical Engineering, Madhav Institute of Technology and Science, Gwalior, 474005, India

J. Eng. Ind 109(3), 206-212 (Aug 01, 1987) (7 pages) doi:10.1115/1.3187120 History: Received February 10, 1987; Online July 30, 2009

Abstract

Facing and taper turning tests (also known as accelerated cutting tests) are commonly used for the evaluation of machinability of materials. Of late, it has been reported that instantaneous values of tool-chip interface temperature, tool wear, shear angle, etc, in longitudinal turning are different from the corresponding values in accelerated cutting. This effect has been attributed to shear strain acceleration phenomenon. Materials behavior during accelerated cutting changes in a manner different than that in longitudinal turning. To test this hypothesis, experiments have been conducted using HSS as tool material and mild steel as work material. It has been concluded that shear flow stress during accelerated cutting is governed by shear strain acceleration and its governing parameters. Shear flow stress value is highest during facing, lowest in taper turning and in between the two during longitudinal turning.

Copyright © 1987 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In