0
RESEARCH PAPERS

Acoustic Emission from the Face Milling Process—the Effects of Process Variables

[+] Author and Article Information
E. N. Diei, D. A. Dornfeld

Department of Mechanical Engineering, University of California, Berkeley, CA 94720

J. Eng. Ind 109(2), 92-99 (May 01, 1987) (8 pages) doi:10.1115/1.3187114 History: Received October 20, 1986; Online July 30, 2009

Abstract

This study investigates the nature of the acoustic emission (AE) signal generated during single and multitooth face milling of steel. For this purpose, cutting tests were conducted on a vertical milling machine to determine the effects of cutting parameters, especially the angle of tool engagement and disengagement, the varying chip thickness, and the number of engaged teeth. The results show good correlation between the rms AE signal and the severity of the contact conditions during chip formation and at tool entry and exit. Cutting forces were also measured and a qualitative correlation between the specific AE rms voltage and the specific cutting force is seen.

Copyright © 1987 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In