0
RESEARCH PAPERS: Papers on Production Engineering

Cutting Performance Comparison of Bonded and Brazed End Mills

[+] Author and Article Information
L. S. Zhang

XIAN Aero-Engine Factory, China

M. M. Sadek

Mechanical Engineering Department, The University of Birmingham, England

D. H. Wale

Marwin Cutting Tools Limited, Leicester, England

J. Eng. Ind 107(2), 153-158 (May 01, 1985) (6 pages) doi:10.1115/1.3185979 History: Received April 05, 1983; Online July 30, 2009

Abstract

In this paper the feasibility of fabricating spiral carbide tipped end mill adhesive using bonding technique has been investigated. Cutting tests were performed and cutting forces, vibrational motion, tool wear, and surface roughness were measured. The cutting performance of the bonded end mill has been assessed in relation to those of the brazed tool. This investigation shows that the performance of the bonded end mills is almost identical to that of the commercially available brazed ones in both cases of normal cutting conditions with and without coolant. The vibration characteristics show that the damping effect of the bond layer is insignificant due to dimensions and geometry of the bond line. Infrared prints demonstrate a pronounced heat isolation due to the low thermal conductivity of the adhesive, which can be improved by mixing metallic particles in the bonding material.

Copyright © 1985 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In