0
RESEARCH PAPERS: Production Engineering

A Method for In-Process Failure Prediction in Cold Upset Forging

[+] Author and Article Information
O. Ettouney, D. E. Hardt

Department of Mechanical Engineering, Massachusetts Institute of Technology, Cambridge, Mass. 02139

J. Eng. Ind 105(3), 161-167 (Aug 01, 1983) (7 pages) doi:10.1115/1.3185883 History: Received December 27, 1982; Online July 30, 2009

Abstract

This paper addresses the prediction of plastic tensile instability and ductile fracture of a specimen undergoing a compression test (simple upsetting). The method used to predict failure is based primarily on Thomason’s approach for predicting tensile plastic instability in compression tests. However, to apply this method to in-process prediction, a means for calculating the flow stress-strain properties from in-process measurements is needed. A method is introduced that is derived from Bridgman’s correction factor for effective stress after necking occurs in the tensile test, but with a different approach that is suitable for compression specimens. The new correction factor enables one to correct the effective stress after barreling occurs, which eliminates the need for an ideal test (without barreling) to find the effective stress of a specimen. The results were in agreement with those derived from an ideal compression test. Stress data found using this correction factor was then used to predict failure using Thomason’s method.

Copyright © 1983 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In