0
RESEARCH PAPERS

Effect of Rake Face Design on Cutting Tool Temperature Distributions

[+] Author and Article Information
P. K. Wright

Carnegie-Mellon University Pittsburgh, Pa.

S. P. McCormick, T. R. Miller

School of Engineering, University of Auckland, Auckland, New Zealand

J. Eng. Ind 102(2), 123-128 (May 01, 1980) (6 pages) doi:10.1115/1.3183843 History: Received August 09, 1979; Online July 30, 2009

Abstract

Turning experiments have been carried out on a low carbon iron using steel tools of different side rake face geometry. Temperature distributions have been determined using a recently developed metallographic method. It has been found that when using tools which have a controlled chip-tool contact length of 0.5 mm. the temperatures are ∼30 per cent lower than when using conventional, 6 deg rake tools and, as a result, tool life is longer. Theoretical equations are described which allow the calculation of the temperature distribution along the chip tool interface and the tribological conditions in this region are also considered in detail. There is good agreement between the calculated and measured temperature distributions.

Copyright © 1980 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In