0
RESEARCH PAPERS

Failure of Cemented Carbide Tools When Executing Intermittent Cuts

[+] Author and Article Information
S. M. Bhatia, P. C. Pandey, H. S. Shan

Dept. of Mechanical and Industrial Engineering, University of Roorkee, Roorkee, India

J. Eng. Ind 101(4), 391-396 (Nov 01, 1979) (6 pages) doi:10.1115/1.3439525 History: Received July 25, 1978; Online July 15, 2010

Abstract

Premature failure of the cutting edge is a major problem associated with the application of cemented carbide tools in intermittent cutting operations. In such cases, unlike in continuous cutting, the tool edge fails due to fracture, well before the permissible limit of wear is approached. This paper reports some of the findings pertaining to the behavior of cemented carbide tools when used in interrupted cuts on a lathe. Based on the type of tool failure observed, the operating speed and feed range has been divided into four regions and the mode of tool failure in each region has been discussed. From the experimental results obtained, it is possible to specify a safe operating range for cemented carbide tools when executing intermittent cuts.

Copyright © 1979 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In