0
RESEARCH PAPERS

Limit Analysis of Hollow Disk Forging—Part 2: Lower Bound

[+] Author and Article Information
F. Sauerwine

Metals and Minerals Research, Gulf & Western Natural Resources Group, Palmerton, Pa.

B. Avitzur

Lehigh University, Bethlehem, Pa.

J. Eng. Ind 100(3), 347-355 (Aug 01, 1978) (9 pages) doi:10.1115/1.3439440 History: Received June 24, 1977; Online July 15, 2010

Abstract

A lower bound for hollow disk forging is presented. The hollow disk is separated into several regions by permissible surfaces of stress discontinuity. The friction stress in each zone is assumed to be either variable or constant; the overall friction stress distribution has characteristics similar to experimentally determined distributions. A statically admissible stress field describes the stress distribution within each deforming zone. The dependence of the relative average pressure, the friction stress distribution and the neutral radius upon friction and ring geometry is given. It is found that only for thin rings is the friction stress constant over most of the interface. Finally, it is proposed that friction factors being measured by use of the mathematically calibrated ring compression test may be somewhat high.

Copyright © 1978 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In