0
RESEARCH PAPERS: Mechanisms Papers

The Effect of Abrasion Resistance and Thermal Properties of the Cemented Carbide Cutting Tool Grade on the Flank Wear Characteristics

[+] Author and Article Information
A. Ber

Technion—Israel Institute of Technology, Haifa, Israel

J. Eng. Ind 95(3), 794-796 (Aug 01, 1973) (3 pages) doi:10.1115/1.3438227 History: Received July 31, 1972; Online July 15, 2010

Abstract

Correlation of the wear characteristics with abrasion resistance factor—1/(vol. loss) in a standard test—has been established in a low speed range where the temperatures involved in the cutting action are relatively low. It was found that a lower abrasion resistance factor produced, (in specified time and cutting conditions except speed, which was a variable), higher flank wear at a range of low speeds—20 to 100 SFPM or 6 to 55 per min—but, when speed is increased, other properties than abrasion resistance are involved, i.e., hot hardness characteristics and thermal conductivity coefficient are able to withstand higher velocities. Speed versus thermal conductivity coefficient curve was established where the cutting time and flank wear levels were constant. Feed and depth of cut were also constants. The investigation demonstrated that thermal conductivity coefficient of the cutting grade material is very significant and plays a major role in its ability to resist transfer of heat from the cutting zone to the flank of the tool, and thus no reduction of hardness due to temperature. This phenomenon results in the ability of the tool to perform in high speed range.

Copyright © 1973 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In