Influence of Hold-Time and Temperature on the Low-Cycle Fatigue of Incoloy 800

[+] Author and Article Information
C. E. Jaske, H. Mindlin, J. S. Perrin

Battelle Memorial Institute, Battelle’s Columbus Laboratories, Columbus, Ohio

J. Eng. Ind 94(3), 930-934 (Aug 01, 1972) (5 pages) doi:10.1115/1.3428273 History: Received July 21, 1971; Online July 15, 2010


A study has been conducted to determine the low-cycle fatigue behavior of solution-annealed Incoloy 800 bar at temperatures from 800–1400 deg F. The experimental work included evaluation of specimens under both continuous, completely reversed strain cycling and under strain cycling with hold time periods at the strain limits. At 1000, 1200, and 1400 deg F, it was found that 10-min hold-times at the tensile strain limit during every cycle significantly reduced the cyclic fatigue life compared to continuous cycling. However, there was little reduction in cyclic fatigue life when 10-min hold-times were introduced at the compressive strain limits or at both the tensile and compressive limits. The ratio of hold-time cyclic fatigue life to no-hold-time cyclic fatigue life decreased as the length of hold time increased (at constant total strain range) and as the magnitude of strain range decreased (at constant hold-time length).

Copyright © 1972 by ASME
Your Session has timed out. Please sign back in to continue.






Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In