0
RESEARCH PAPERS

An Experimental Investigation of Dynamic Factors in Spur and Helical Gears

[+] Author and Article Information
D. R. Houser

Department of Mechanical Engineering, The Ohio State University, Columbus, Ohio

A. Seireg

Department of Mechanical Engineering, University of Wisconsin, Madison, Wis.; Falk Corporation

J. Eng. Ind 92(2), 495-503 (May 01, 1970) (9 pages) doi:10.1115/1.3427789 History: Received July 02, 1969; Online July 15, 2010

Abstract

This paper describes a comprehensive test program for the investigation of the influence of errors and variations in mesh stiffness on the peak stresses developed in spur and helical gears. The study is primarily concerned with speed effects on tooth loads in regions away from resonance. Four sets of specially designed and instrumented gears were tested in an open-loop setup. The interaction between tooth loads and system shaft torques at different operating conditions is also investigated. The results are utilized in the accompanying paper for the development of a generalized dynamic load formula for spur and helical gears.

Copyright © 1970 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In