0
RESEARCH PAPERS

Analysis of Tool Wear: Part II: Applications of Flank Wear Models

[+] Author and Article Information
A. Bhattacharyya, Inyong Ham

Department of Industrial Engineering, The Pennsylvania State University, University Park, Pa.

A. Ghosh

B. E. College, India

J. Eng. Ind 92(1), 109-114 (Feb 01, 1970) (6 pages) doi:10.1115/1.3427693 History: Received July 01, 1969; Online July 15, 2010

Abstract

For machining with cemented carbides and ceramics, a quantitative assessment of tool failure at the flank for establishing “limit criterion” is necessary. The arbitrarily chosen flank wear limit for all cutting speeds is not valid at higher cutting speeds because of the earlier appearance of the “inflection point” which is often taken as criterion of flank-failure. In this paper, proceeding from the basic physical model of flank wear described in Part I of the paper (ASME Paper No. 68—WA/Prod-5), tool-life relations in the form of Taylor’s equations have been theoretically developed, the parameters of which have been compared with, experimental results. Further, the critical points of inflexion where the flank-wear characteristic enters temperature sensitive region resulting in accelerated wear have been uniquely defined. The location of these critical points have also been verified experimentally.

Copyright © 1970 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In