0
RESEARCH PAPERS

Optimum Die Angles and Maximum Attainable Reductions in Rod-Drawing

[+] Author and Article Information
R. M. Caddell

Department of Mechanical Engineering, University of Michigan, Ann Arbor, Mich.

A. G. Atkins

Department of Engineering Science, University of Oxford, Oxford, England

J. Eng. Ind 91(3), 664-671 (Aug 01, 1969) (8 pages) doi:10.1115/1.3591650 History: Received July 18, 1968

Abstract

Die friction and redundant deformation cause working stresses in drawing to be greater than simple homogeneous deformation would demand. At small die angles, frictional effects are large but the influence of redundant deformation is negligible; as die angles increase, the relative effects of these two factors reverse. Because of this interaction, an optimum angle exists for each combination of reduction and coefficient of friction where the drawing stress becomes a minimum. By modifying the normal Sachs equation to include redundant deformation, minima in the curves of drawing stress versus die angle are demonstrated. Additionally, some theoretical considerations of the maximum possible reduction per pass are presented.

Copyright © 1969 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In