0
RESEARCH PAPERS

Performance of Tungsten Carbide, Titanium Carbide, and Oxide Tools in Finish Turning of C-30 Gray Iron

[+] Author and Article Information
I. Ham, T. Hoshi, G. L. Thuering

Department of Industrial Engineering, The Pennsylvania State University, University Park, Pa.

J. Eng. Ind 87(3), 344-348 (Aug 01, 1965) (5 pages) doi:10.1115/1.3670841 History: Received July 20, 1964; Online December 08, 2011

Abstract

Performance data were obtained for tungsten carbide, titanium carbide, and oxide tools in the finish turning of C-30 gray iron. Characteristics of typical wear patterns were examined in relation to their effects on cutting force and surface finish. Using both surface finish and tool wear as tool life criteria, the comparative performance of these tools was evaluated. The oxide tool was superior to the carbide tools except at low cutting speeds. The influence of depth of cut and of a prehoned land on the cutting edge was also studied.

Copyright © 1965 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In