0
RESEARCH PAPERS

Use of Chip Tension to Obtain a Stress-Strain Curve From Metal Cutting Tests

[+] Author and Article Information
I. Finnie, J. Wolak

Department of Mechanical Engineering, University of California, Berkeley, Calif.

J. Eng. Ind 85(4), 351-355 (Nov 01, 1963) (5 pages) doi:10.1115/1.3669889 History: Received July 20, 1962; Online December 09, 2011

Abstract

By pulling the chip at various angles during metal cutting, it has been possible to greatly decrease the shear strains and thus to obtain a wide range of shear strains with a single tool. Using this technique, stress-strain curves for commercial purity aluminum have been obtained at −320 deg F (78 deg K) and 68 deg F (293 deg K). These results lie above those obtained from compression tests on the same material and the difference is ascribed largely to strain rate. Limits are imposed on the chip-pulling technique by an instability which appears when the direction of pulling makes too great an angle with the tool face and by fracture.

Copyright © 1963 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In