0
RESEARCH PAPERS

Analysis of Wire Drawing and Extrusion Through Conical Dies of Small Cone Angle

[+] Author and Article Information
Betzalel Avitzur

Systems & Devices Section, Applied Science Department, Ford Motor Company, Dearborn, Mich.

J. Eng. Ind 85(1), 89-95 (Feb 01, 1963) (7 pages) doi:10.1115/1.3667601 History: Received November 18, 1960; Online December 09, 2011

Abstract

Analytical expressions are derived for the required front pull for wire drawing, as well as the back push for extrusion. The effect of each of the process variables on these forces is presented graphically. The process variables are: the cone’s semiangle (α) initial (Ri ) and final (Rf ) wire radius, material yield limit (σ0 ) at uniaxial load, back pull (σxb ) and front pull (σxf ), coefficient of friction (μ) or shear factor (m), die land (L), exit velocity (vf ), and entrance velocity (vi ). The power balance is set for these powers: (1) Internal power of deformation of the wire, (2) power involved with the back force on the wire, (3) power involved with the front force on the wire, (4) power losses due to friction between the wire and the die.

Copyright © 1963 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In