0
RESEARCH PAPERS

Machinability of Nodular Cast Irons: Part I—Tool Forces and Flank Adhesion

[+] Author and Article Information
I. Ham, K. Hitomi, G. L. Thuering

Department of Industrial Engineering, The Pennsylvania State University, University Park, Pa.

J. Eng. Ind 83(2), 142-153 (May 01, 1961) (12 pages) doi:10.1115/1.3664446 History: Received February 01, 1960; Online December 09, 2011

Abstract

Three grades of nodular cast iron (60, 80, and 100) were tested to determine the cutting and feed forces required to machine the materials, to determine the performance of several grades of carbide and oxide cutting tools, and to investigate the flank adhesion phenomenon. Cutting characteristics for grade 80 and grade 100 were found to be the same as for high-strength gray cast irons with similar Bhn values. Flank adhesion, with accompanying sharp increases in cutting force values, was encountered only when grade 60 was machined with carbide tools. An attempt was made to correlate tool composition and flank adhesion.

Copyright © 1961 by ASME
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In