0
RESEARCH PAPERS

Determination of the Temperature of a Machined Surface

[+] Author and Article Information
T. H. Chu, J. Wallbank

Department of Engineering, University of Warwick, Coventry CV4 7AL, U.K.

J. Manuf. Sci. Eng 120(2), 259-263 (May 01, 1998) (5 pages) doi:10.1115/1.2830122 History: Received November 01, 1996; Revised June 01, 1997; Online January 17, 2008

Abstract

A technique for measuring temperature close to the primary cutting edge in turning has been developed. The cutting temperatures of a 0.16 percent carbon bright drawn mild steel, have been measured for a range of cutting speeds and feedrates at a constant depth of cut. Tool nose radius was also varied. The correlations for the workpiece temperature of cutting speed and feedrate have been developed. The results show that the temperature correlates well with cutting speed and feedrate but the nose radius has little effect. Cutting forces were measured by a dynamometer and these were used to find the non zero forces at zero feedrate. These forces have been related to the deformation of the work material near the cutting edge of the tool and a method for calculating the cutting temperatures from these has been proposed.

Copyright © 1998 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In