0
TECHNICAL BRIEFS

In-process Evaluation of the Overall Machining Performance in Finish-Turning via Single Data Source

[+] Author and Article Information
X. D. Fang

Department of Mechanical Engineering, University of Wollongong, NSW 2500, Australia

Y. L. Yao

School of Mechanical and Manufacturing Engineering, University of New South Wales, NSW 2033, Australia

J. Manuf. Sci. Eng 119(3), 444-447 (Aug 01, 1997) (4 pages) doi:10.1115/1.2831127 History: Received October 01, 1993; Revised June 01, 1996; Online January 17, 2008

Abstract

Sensor fusion often uses multiple sensors to evaluate a single quantity. The work presented in this paper attempts to use information from a single sensor to estimate overall machining performance (characterized by cutting forces, chip breakability, surface roughness, and dimensional deviation due to tool wear). In particular, the performance is aimed at reflecting the in-process changes of the above-named quantities with respect to tool wear progression (major flank, crater and minor flank wear). 3-D cutting force measured by a tool dynamometer is fully utilized by aggregating multivariate time series models and neural network techniques. Dispersion analysis is used to extract signal features which correlate well with progressive tool wear. The results have shown the effectiveness of the proposed method which also has the obvious merit of simplicity.

Copyright © 1997 by The American Society of Mechanical Engineers
Your Session has timed out. Please sign back in to continue.

References

Figures

Tables

Errata

Discussions

Some tools below are only available to our subscribers or users with an online account.

Related Content

Customize your page view by dragging and repositioning the boxes below.

Related Journal Articles
Related eBook Content
Topic Collections

Sorry! You do not have access to this content. For assistance or to subscribe, please contact us:

  • TELEPHONE: 1-800-843-2763 (Toll-free in the USA)
  • EMAIL: asmedigitalcollection@asme.org
Sign In